Menu
VW Anchor Load Cells VWLC-5000
VW Anchor Load Cells VWLC-5000
Zoom
Load Cells

VW Anchor Load Cells VWLC-5000

The VWLC 5000 series Vibrating Wire Anchor Load Cells consist of a cylinder of high strength steel with 3 to 6 vibrating wire strain sensors (depending on capacity) mounted parallel to the longitudinal axis arranged equidistant around the circumference which measure the compression of the cylinder under load.

They are manufactured with a centre hole to accommodate anchors, rock bolts and tendons.

With the multi-sensor configuration, it is possible to obtain accurate readings under mildly eccentric loading conditions as the sensors are read individually.

The readings from the individual sensors are averaged and when used in conjunction with a calibration factor, supplied with each cell, allow the applied load to be calculated.

In multi-strand anchors it is therefore possible to tension the strands uniformly by monitoring the load in each sensor as appropriate.

The abutment plate (provided locally) is normally made to suit specific site requirements and load distribution plate pairs (supplied by Geosense) should be used to minimise eccentric loading and provide a smooth parallel bearing surface and evenly spread the load to the cell. These should be inserted between the load cell and the anchor head.

Technical Specification

Thermistor
3k Ohms at 25°C
Internal diameters
25, 50, 77, 112, 144, 165, 190, 225, 230mm
Accuracy (system accuracy depends on loading conditions)
0.5% FS (0.25% FS available on request)
Resolution
0.05% FS
Output
1200 - 2800 Hz
Temperature range
-20°C to + 80°C